ASTM D1004-13 Tear Resistance (Graves Tear) of Plastic Film and Sheeting
ASTM D1004-13 covers the determination of tear strength or tear resistance of flexible plastic film and sheeting. The site of tear is initiated by a high stress concentration caused by the 90° angle in the specimen. This test method aims to measure force to initiate tear for plastic films that do no exhibit brittle failure or do not elongate greater than 101.6 mm (4 in.).
The challenges of testing to this standard are:
- Non-repeatability of results
- Preventing specimen slippage
- Non-repeatability of results – ASTM D1004-13 requires the operator to exclude results that deviate markedly from the mean value. When using Bluehill® Universal, the operator can use visual pass/fail indicators to alert users when the results are out of specification. Bluehill Universal also offers a TestCam module to record a video of the test, enabling users to replay videos to ensure a test performed as expected.
- Preventing specimen slippage – When testing thin films, the specimens typically undergo thinning as they are stretched. Instron self-tightening grips are primarily designed for the precision testing of films and other flexible materials exhibiting a large reduction in cross-section area under load.
We recommend reading and reviewing ASTM D1004-13 in order to fully understand the test setup, procedures, and results requirements.
Bluehill Universal Software is built from the ground-up for touch interaction and an intuitive user experience. Discover simpler and smarter testing with features such as pre-loaded test methods, QuickTest in seconds, enhanced data exporting: and Instron Connect – a new feature that provides a direct communication link to Service. Users of previous versions of software such as Bluehill 2 and Bluehill 3 can easily upgrade to the newest version of Bluehill.
- 2.6 MB
Bluehill® Software TestCam Video Recording and Playback module enables the user to record and replay the actual test event, allowing the operator to examine specific regions and points of interest for materials and components that produce distinct test curves.
- 178.6 KB
5900 Universal Testing Systems are engineered for precision, built for durability, and offer the flexibility for changing requirements. They are designed with standard and optional features that increase testing efficiency and improve the testing experience for the operator. A wide range of models are available for testing capacities from < 100N up to 600kN.
- 6.8 MB
Серия испытательных машин 3300 была разработана для обеспечения соответствия требованиям, предъявляемым типовыми процедурами стандартизационных и контрольных испытаний. Эта серия обеспечивает пользователя высоким качеством, присущим марке Instron, при самой приемлемой цене.
- 0.6 MB